Thetford Aqua-Magic® IV

Thetford Aqua-Magic® IV

StreakerDue to age and difficultly of installation, replacement of stool model recommended.
  1. Remove stool.
    1. Remove two bolts, one on each side.
    2. Remove water line located at the rear of stool. (MAKE SURE WATER IS OFF)
  2. Locate flush line between vacuum breaker and bowl.
    1. Next separate the top from the bottom.
      1. Remove eight (8) screws from under rim.
      2. Gently pry apart. [Photo 2A]
    2. Cut a small section out of flush line. (Between two smooth sections.)
    3. Using a hair dryer, warm plastic line so it can easily slip over T-valve. The arrow on the T-valve should point toward the bowl. (THIS IS VERY IMPORTANT)
    4. With the two clamps provided, secure T-valve in place. [Photo 2B-D]
    5. At the back of the base, drill a 11/32 hole in the flat section for line supply.
    6. Feed line through hole. (A tight fit is necessary to avoid any leaks.) [Photo 2E-F]
    7. Reassemble stool making sure blade spring is in place.
    8. Reattach ¼ line to reservoir. Apply silicone on stem.
  3. Reinstall stool making sure all gaskets, bolts and water connections are secure.
  4. Mounting the dispenser on the wall.
    1. Locate reservoir to the back or side of the wall providing easy access for filling.
    2. Keep level or lower than back of stool.
    3. Screw reservoir into place with the three screws provided with the kit.
  5. FINAL CHECK LIST
    1. Check water lines for leaks.
    2. Check stool by flushing.
    3. Add a few ounces of Blue Streak Chemical® to reservoir.
    4. Flush Stool. Finish filling reservoir.

2A
2A

2B-D
2B-D

2E-F
2E-F

Q: How Do I Winterize the Blue Streak Dispenser?

A: Run the chemical level low [1 to 2 inches] in the reservoir and winterize your unit as you would normally. To remove chemical from the reservoir; unscrew the tank from the wall leaving tubing attached to tank and pour chemical into another container.